Benefits

• Cuts down the lead time between order and delivery, by eliminating the need for us to schedule a site measure before manufacture.
• Lower cost to you, because we don’t need to cover the cost of getting there and spending the time to measure.
• The sizes, specifications, method of attaching and so on will all be to your preferences.

Drawbacks:

• You take the risk on sizes and colour rather than us. If we’ve manufactured to the sizes you’ve provided, but you’ve made a mistake on the size, then you will absorb the cost of reworking the product to be the correct size.

Overview of what we need in writing :

• If ordering for manufacture only, we need as much information as possible, including:
  • Clear indication of the product you’re after
  • Colour
  • Height & Width (in that order) in millimetres (mm).
  • Mesh type
  • Other requirements
    • Insect Screens
      • Whether a ‘tailpiece’ will be required (we don’t cut out the opening though). Note: Give us the full height of the combined screen / tailpiece.
      • position and number of holes for plunger pins
      • position of an finger pull tabs (as well as an indication of whether the tab will be on the ‘spline’ side of the mesh or the ‘frame’ side of the mesh (important, because “inside / outside” is actually a vague description because a screen can be fitted either way around depending on other requirements.
      • Type and location of other permanent fixings
      • Other loose fittings required
    • Doors:
      • Hinged or Sliding
      • Which “Hand” (Right or Left: viewed from OUTSIDE the property)
      • Height of handle (go either 100mm above or below highest/lowest point of your handle to ensure clearance)
      • Specification (Flydoor, Barrier, INVISI-GARD – special grilles)
    • Other products:
      • Please be as clear as possible, in writing and/or diagrams about your specific requirements.